The firmware download and upgrade to the Phantom 4 and RC needs to complete successfully. The firmware is the critical software, which makes the components on your drone work. So it is vital the firmware update process runs really smooth. If a firmware download is interrupted or the firmware file is incomplete, then you would have to start the download process all over again. If the firmware file is incomplete or corrupt you could damage a component or your drone will just not fly.
Never be in a hurry to do a firmware update. The Phantom 4 firmware update needs approximately 1 hour from start to finish to be on the safe side.
It is also best to update the DJI Apps first, then the remote controller followed by the Phantom 4 quadcopter. So, check for updates for the following;. Give yourself plenty of room and a quiet spot so you can concentrate without any disturbance. Do not perform firmware update while the aircraft is still flying in the air.
Remove the propellers before starting the firmware process. The best advice is to have fully charged batteries in your quadcopter, remote controller and mobile device cellphone or tablet. When downloading the firmware update package, make sure you have a very good internet connection.
Download the required app before beginning a firmware update:. Updating firmware can be a time-consuming process and will require a stable internet connection and fully charged devices.
Measure recommends updating firmware before going out into the field whenever possible. Back to home. They wrote a ticket.
It is so frustating to not being able to fly it! What's annoying is that the issues change user to user. The wrong version detected, or not detected I have really not seen much about till the last few days.
Mainly on iOS devices. I wonder if that's an issue with a dji go app update? I can connect my remote to the app no problem. There must DJI-Jamie Offline. Second Officer. I had issues on my iPad Mini 2. I could control aircraft but not see anything else in the app.. Did a full reset in iPad Mini 2 via iTunes not the onboard reset - make a back up first.
Upgraded to 2. Both are now at 2. For whatever reason, Apple told DJI that the reset had to be done through iTunes and not on the device.. I didn't have much on the iPad so I just did a straight full factory fresh reset and then went to the app store to reload recognized apps I had downloaded, including the current DJI Go app..
Hope it helps some.. Advanced Bold Text Color Upload. You need to log in before you can reply Login Register now. Thanks Doriano. Sorry for that, I didn't write it correctly.
I know they have different versions, what I meant is that the aircraft is at the latest version and the RC not. I tried with the stick but that doesn't work either. I succeeded with the aircraft, but not with the controller.
They updated the app a few days ago, I'll try installing that when I get home tomorrow and see if it works then! I'll do it tomorrow when I get home and have access to the drone! I just tried this.. I get a green led while the aircraft is warming up, but no update shows up in the app.. I'm starting to think it's an issue with the DJI Go app. Did anyone update the firmware successfully using DJI Go 2.
I have the Pro version of the P3 and yes, I do get video feed.. Can you control the gimbal with the dial? If so, that also confirms u actually do have the link to the drone.
It think it may be worth getting a list of facts here, like: RE signal lost reported FW version on the drone confirmed to 1. Gimbal angle can be controlled by RC controller?
The aircraft is responding to rc commands? Shot on DJI. Short Film. DJI Pro. Aerial Cinematography System Professional aerial shooting for unrivaled efficiency Inspire 2. Public Safety. Oil and Gas. Aerial Surveying and AEC. About us. DJI Agriculture. Agras MG Series Comparison. Repair Services One-stop aftersales service for worry-free repairs.
0コメント